10
OPERATING MANUAL
VERSION 11/2015 ORDER NUMBER DOC2333553
2.5 PROCESSIBLE WORKING MATERIALS
Application
Water-based products
Solvent-based products
Low viscosity (<40 sec. DIN No. 4)
Medium viscosity (40 to 60 sec. DIN No. 4)
High viscosity ( >60 sec. DIN No. 4)
UV - sensitive products
Shear sensitive products
Humidity sensitive products
Legend
recommended limited suitability less suitable
Abrasive working materials and pigments!
Greater wear of parts carrying the product.
Do not use any grainy and abrasive working materials with large, sharp-edged
pigments.
Use the application-related model ( ow rate/cycle, material packaging, valve seat,
etc.), as speci ed in Chapter 5.5.
Check if the uids and solvents used are compatible with the pump construction
materials as indicated in Chapter 5.5.1.
NOTICE
Wear caused by abrasive working materials is not covered by the warranty.
To Next Page
Loading...
