What if there is foreign body in suction valve of WAGNER Water Pump?
If there is a foreign body in the suction valve of your WAGNER Water Pump, dismount the suction valve housing, and clean and check the valve seat.
What to do if WAGNER Water Pump does not work and there is no pressure indication?
If the WAGNER Water Pump isn't working and there's no pressure indicated on the pressure gauge, it could be that the air pressure regulator is defective. Try briefly disconnecting the compressed air supply. If that doesn't work, you may need to repair or replace the pressure regulator.
Why is my WAGNER Water Pump spray jet collapsing?
If your WAGNER Water Pump's spray jet collapses, causing pulsation, it might be due to several reasons. One possibility is that the viscosity of the spraying product is too high; in this case, thin the spraying product. Another reason may be that the spraying pressure is too low, so you should increase the incoming air pressure or use a smaller nozzle. Also, check if the valves are clogged, and if so, clean the pump, soaking it in cleaning agent if needed. Ensure that the control air filter or work air filter is not clogged, and clean it if necessary.
What to do if WAGNER Leopard 35-150 runs but does not suck up any product?
If the WAGNER Water Pump runs evenly but doesn't suck up any product, the issue might be a loose union nut in the suction system, causing the pump to take in air. Tighten the union nut to resolve this. Another potential cause is a clogged suction filter, which you should clean. Also, check if the ball in the suction or piston valve is stuck; if so, clean the balls and valve seats.
What to do if WAGNER Water Pump is working with a closed spray gun?
If the WAGNER Water Pump is working even when the spray gun is closed, it indicates that packings, valves, or pistons are worn out and need replacement.
What to do if there is no pressure on my WAGNER Leopard 35-150 Water Pump?
If there is no pressure indication on the pressure gauge of your WAGNER Water Pump (and the air pressure regulator might be defective), briefly disconnect the compressed air supply or repair or change the pressure regulator.
Explains warning categories, symbols, and their meanings.
Details ATEX classification and its meaning for device suitability in hazardous areas.
Covers electrical safety, safe work environment, and personnel qualifications for operators.
Outlines safety for all personnel regarding high-voltage, dangerous fluids/vapors, and PPE.
Details safe handling of spray devices, noise protection, and essential grounding procedures.
Covers essential training for operators and immediate actions for emergency stops.
Details key operational tasks and crucial procedures for pressure relief during work interruptions.
Covers maintenance personnel, specific instructions, and essential daily/periodic safety checks.
Provides a table of common malfunctions, their causes, and recommended solutions for rectification.
Describes essential tests including ground connection, leak testing, and general inspections after repair.
General| Model | Leopard 35-150 |
|---|---|
| Voltage | 230 V |
| Frequency | 50 Hz |
| Flow Rate | 35 l/min |
| Max Head | 15 m |
To Next Page
