13
Startup
Once the assembly process has been completed your Wallbox Commander 2 is ready to be used.
However, please review the information below in detail before beginningto operate your Wallbox
Commander 2:
• Do not use your Wallbox Commander 2 for purposes not described in the section Product Description.
• Never open the cover of your charger when it is connected to the power supply.
• Special precautions must be taken with electronic implants. Please contact your medical device
manufacturer to find out the potential eects that the charging process may cause to it.
• Review and confirm all the steps that have been carried out.
Power Sharing Smart
If your charger is going to be part of a Power Sharing Smart infrastructure, please be sure you have
the instructions to perform this installation. In case of any doubt contact your sales agent.
User Guide
Follow the user Guide to begin setting up your Wallbox.
• Available at https://wallbox.com
Power Boost
If your charger is going to be part of a Power Boost, please be sure you have the instructions to
perform this installation. In case of any doubt contact your sales agent.
Maintenance
Take some precautions to ensure correct maintenance:
• The are no parts within your Wallbox that the user has to maintain. Only a qualified electrician may open
and modify your Wallbox.
• Make sure that the power supply is turned o before you start cleaning your charger.
• If you want to clean your Wallbox we recommend that you use a soft, dry or damp cloth. Do not use a
spray or direct water stream to clean your Wallbox charger.
• It is mandatory to use the plug holder provided, in order to protect the connector from falling, dirt and
other weather elements.
• In case it is needed to reopen the device, use only the tool (I-1) provided for this procedure included in
the Wallbox box. The use of any other tool or means may cause damage in the charger, which wouldn’t
be covered by the product warranty.
To Next Page
Loading...
