Why is residual regenerant being delivered to service in Water Right Sanitizer Plus ASP2-1054 Water Dispenser?
If residual regenerant is being delivered to service in your Water Right Water Dispenser, first check that the incoming water pressure is at least 25 psi. Then, verify that the injector size is correct for your application and replace it if necessary. Finally, inspect the drain line for any restrictions or debris and clean it.
General| Brand | Water Right |
|---|---|
| Model | Sanitizer Plus ASP2-1054 |
| Category | Water Dispenser |
| Language | English |
Explains the four positions of the bypass valve: normal, bypass, diagnostic, and shut off.
Covers general warnings, lubrication, site requirements, and plumbing considerations.
Guides through initial water filling, system regeneration sequence, and leak checks.
Instructions for setting the current hour, minutes, and day of the week.
Steps to set water hardness, days between regeneration, and other programming parameters.
Describes automatic regeneration, manual regeneration initiation, and process steps.
Covers system behavior during power outages and how to replace the control valve battery.
Addresses problems with no display, incorrect time, and water flow indication.
Troubleshooting for incorrect regeneration times and flashing time of day indicators.
Diagnosing and resolving motor position errors and stalling conditions.
Addresses motor timing errors, alternating valve issues, and stalled motor conditions.
Troubleshooting for motor stalling, invalid motor states, and regeneration cycle errors.
To Next Page