WaterLogic WL Cube - Page 34

36.
Replace UV Lamp – See separate section in this manual for directions on how to Replace the
UV Lamp.
37.
Re-fit the top cover and insert the two screws at the rear of the machine that secure it
38.
Turn on the water supply at the isolation point
39.
Reconnect the power lead and insert it into the rear of the
machine. Turn on the Red Power Switch.
40.
Taste the water one final time, if you detect any hint of taste, flush 3 more gallons of water to
further flush the Cube.
41.
Check the machine is heating and cooling the water by dispensing some hot and cold water
and checking the temperatures.
CUBE Operating, Installation, and Service Manual Page 34 - Revision: 6-23-2015