Figure 3–19: Screwing cap nut onto fitting
#1 knurled compression fitting
#2 locking cap nut
3.13 Cleaning the exterior of the equipment
Warning: To avoid electric shock:
• Ensure that the electrical power to the equipment is interrupted.
• When cleaning the surface of the equipment, apply water to a cloth, and then wipe
the instrument or device. Do not spray or otherwise apply water directly onto any
equipment surface.
Warning: To avoid personal injury, use eye and hand protection during the cleaning
process.
Required tools and materials
• Chemical-resistant, powder-free gloves
• Protective eyewear
To clean the exterior of the equipment:
Clean surfaces of the equipment using only a clean, soft, lint-free paper towel or clean cloth
dampened with water.
December 4, 2019, 715005052 Version 02 (previously released as Rev.B)
Page 88
To Next Page
Loading...
