What to do if Waters Security Sensors Delta between previous and current timestamp is incorrect?
If the delta between the previous and current timestamp is incorrect on the Waters Security Sensors, cycle power to the detector. If the error persists, contact Waters Technical Service to replace the personality card.
How to fix Waters Security Sensors lamp energy low?
If the Waters Security Sensors indicates lamp energy is low, first, clear the flow cell and establish flow. If the problem persists, replace the lamp. If the issue still continues, contact Waters Technical Service.
What to do if Waters Security Sensors thermal controller disabled?
If the thermal controller is disabled on your Waters Security Sensors, cycle power to the detector. If the problem persists, contact Waters Technical Service.
How to fix Waters Security Sensors lamp hours counter exceeded?
If the Waters Security Sensors lamp hours counter has been exceeded, replace the lamp.
What to do if Waters Security Sensors Vcc fuse failed?
If the Vcc fuse has failed in the Waters Security Sensors, cycle power to the detector. If the problem persists, contact Waters Technical Service.
What to do if Waters Security Sensors 24-Volt fuse failed?
If the 24-Volt fuse has failed in the Waters Security Sensors, cycle power to the detector. If the problem persists, contact Waters Technical Service.
What to do if Waters Security Sensors 15-Volt fuse failed?
If the 15-Volt fuse has failed in the Waters Security Sensors, cycle power to the detector. If the problem persists, contact Waters Technical Service.
How to fix Waters Security Sensors communication error?
If you are experiencing a communication error with Waters Security Sensors, which may result in data point loss, cycle power to both the detector and the data system PC. If the problem continues, contact Waters Technical Service.
What to do if Waters Security Sensors lamp failure?
If the Waters Security Sensors indicates a lamp failure, check the lamp icon, cycle power to the detector, and then replace the lamp.
What to do if Waters Security Sensors lamp lighting failure?
If the Waters Security Sensors experiences a lamp lighting failure, cycle power to the detector. Check the lamp power connection. If the issue persists, replace the lamp.
General| Technology | Ultra Performance Liquid Chromatography (UPLC) |
|---|---|
| Flow Rate Range | 0.001 to 2.000 mL/min |
| Maximum Pressure | 15, 000 psi (1, 034 bar) |
| Temperature Range | 4 °C to 65 °C |
| Data Sampling Rate | up to 80 Hz |
| Detector Options | Photodiode Array (PDA), UV/Vis, Fluorescence, Evaporative Light Scattering |
| Detection Wavelength Range | 190 to 800 nm |
| Column Compatibility | UPLC Columns (1.7 μm particle size) |
To Next Page
