Watson-Marlow 730 U - Page 2

11.2 Wiring the US NEMA module 20
11.3 Earth screening of control cables on NEMAmodule 20
12 Start-up check list 21
13 Control wiring 22
13.1 Upper D-connector 22
13.2 Lower D-connector 22
13.3 Standard - 25 way D: Inputs and Outputs 22
13.4 Standard - 25 way D: power supply limits 30
13.5 N - Modules Standard and SCADA 30
13.6 Standard N - Module 31
13.7 SCADA N-Module 36
14 Switching the pump on for the first time 47
14.1 Selecting the display language 47
14.2 First-time start-up defaults 49
15 Switching the pump on in subsequent power cycles 51
16 Mode menu 52
17 Manual 53
17.1 START 53
17.2 STOP 54
17.3 INCREASING AND DECREASING FLOW RATE 54
17.4 MAX FUNCTION (Manual mode only) 55
18 Flow calibration 56
18.1 Setting the flow calibration 56
19 Analog mode 59
19.1 Analog calibration 60
19.2 Calibrate Input 1 61
19.3 Setting a high signal 62
19.4 Setting high flow calibration 63
19.5 Setting a low signal 64
19.6 Setting low flow calibration 65
20 MemoDose mode 67
20.1 To configure MemoDose 67
20.2 Set flow rate 67
2 m-730un-en-08.1