Status word
3 Guard (Guard enabled models only) (1=guard open)
4 Over current error
5 Under voltage error
6 Over voltage error
7 Over temperature error
8 Motor stalled
9 Tacho fault
10 Leak detected
11 Low setpoint - out of range
12 High setpoint - out of range
13 Reserved
14 Reserved
15 Reserved
Device Related Diagnostic Data
Byte 1, 2, 3, 4, 5, 6* Mandatory Slave Bytes
8 bit Byte 7 Header byte
8 bit Byte 8 Pump model
8 bit Byte 9 Pump head
8 bit Byte 10 Tube size (high byte)
8 bit Byte 11 Tube size (low byte)
8 bit Byte 12 Min speed (high byte)
8 bit Byte 13 Min speed (low byte)
8 bit Byte 14 Max speed (high byte)
8 bit Byte 15 Max speed (low byte)
32 bit Byte 16, 17, 18, 19 Software version, Main CPU
32 bit Byte 20, 21, 22, 23 Software version, HMICPU
32 bit Byte 24, 25, 26, 27 Software version, Flash
32 bit Byte 28, 29, 30, 31 Software version, PROFIBUS CPU
*Note: Bytes 1-6 may not be visible, depending on the Master system used.
44 m-730un-en-08.1
To Next Page
Loading...
