Form: AZ2-MS000248-EBUS-Adapter-1B.doc Page 1 of 1
Description
The MS000248 E-BUS Adapter
Hub is used to provide a
connection point for multiple E-BUS
Sensors or Modules.
The E-BUS Adapter Hub is used to
provide a connection point for
multiple E-BUS Sensors or AZ 2
Expansion Modules. This E-BUS
Adapter Hub has four ports. One
port is used to connect the Hub to
an E-BUS Expansion Port on the
AZ 2 or GPC-XP Controller or an
AZ 2 Expansion Module using the
supplied EBC cable of the desired
length. This leaves three ports
available for E-BUS Sensors and
other Expansion Modules.
The EBC Cables that connect to
the hub are plenum-rated high flex
cables with EBC Connectors on
each end to allow for multiple connections of the E-BUS cables between the Sensors, Modules, and
the AZ 2 or GPC-XP Controllers.
MS000248 - E-BUS Adapter Hub
0.762
1234
-AMP
0.327
0.405
ADAPTER HUB
TOP VIEW
ADAPTER HUB
SIDE VIEW
ADAPTER HUB
LEFT END
VIEW
ADAPTER HUB
RIGHT END
VIEW
MS000248 E-BUS ADAPTER HUB
Technical Data MS000248 E-BUS Adapter Hub
Terminations Hub - (4) EBC Connectors
.
Three Year Warranty
WattMaster reserves the right to change specifications without notice
To Previous Page
Loading...