Watts Aerco INN 1060N - Page 121

Innovation - Edge [i] Installation, Operation, Maintenance Manual
CHAPTER 8 – WATER HEATER MANAGEMENT
OMM-0143_A • GF-216 • 9/6/2019 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 121 of 170
Figure 8.6-5: Operating Controls: Anti-Cycling Control Screen
TABLE 8-6f: Operating Controls → Valve Configuration Parameters
Menu Item Display
Available Choices or Limits
Default
Minimum
Maximum
Select Output
Standard Setup
Read Only
Select the output you want to configure.
Output Signal Type
Current or Voltage
Voltage
Select the output signal type of the selected output.
Control Mode
On/Off
Read Only
Select the Control Mode for the selected output (Standard Setup)
Valve Feedback
Enabled/Disabled
Enabled
Allows Valve Feedback functionality to be enabled; Valve Feedback Status appears.
Valve Feedback Status
Open, Close
Read Only
Displays the status of the selected valve.
Figure 8.6-6: Operating Controls: Valve Configuration Screen