Why is the water not clean in my Wave PACIFIC Hot Tub?
The water in your Wave Hot Tub might not be clean due to several reasons. You may need to increase the filtering time, or the filter cartridge may be dirty and needs cleaning or replacing. Consider that the pool filled water quality may be poor, requiring a complete water change.
What to do if Wave PACIFIC pool is leaking?
If your Wave Hot Tub pool is leaking, it's likely because the spa pool is torn or punctured. Use the provided repair kit to fix it.
What to do if Wave Hot Tub pump does not heat properly?
If your Wave Hot Tub pump isn't heating the water properly, there are a few things to check. First, make sure the temperature is set high enough. If it is, the filter cartridge might be dirty, so try cleaning or replacing it. Also, ensure the water level is at least at the minimum. If none of these steps work, the heating element may be defective.
What to do if bubble massage system does not work in Wave Hot Tub?
If the bubble massage system in your Wave Hot Tub isn't working, it could be due to a few reasons. The pump might be overheating; if so, cut off the power and wait until it cools down. The auto shut-down feature (30min) may be activated; press the bubble button to reactivate it. If neither of these solutions works, there might be a malfunction of the pump unit, and you will need to call for service.
How to fix water filtration that doesn't work in Wave PACIFIC Hot Tub?
If the water filtration in your Wave Hot Tub isn't working, start by checking the filter cartridge; a dirty cartridge can prevent proper filtration, so clean or replace it. Also, inspect the inlet and outlet for any blockages and clean them if necessary. Air inside the pump can also cause this issue, so ensure the water is filled to the minimum water level. If the problem persists, there may be a malfunction of the pump unit, and you will need to call for service.
What to do if Wave PACIFIC leakage?
If your Wave Hot Tub is leaking, inspect the spa for tears or punctures. If you find any, use the provided repair kit.
What to do if Wave PACIFIC pump leakage?
If your Wave Hot Tub pump is leaking, check the adaptor seal to ensure it's in the correct position; if not, replace it. If water is leaking from the pump body, check the pump body.
How to fix Wave PACIFIC Hot Tub control panel screen that does not operate?
If the control panel screen on your Wave Hot Tub isn't working, first check the power source to ensure there isn't a power failure. Reset the RCD plug and check if the wiring system is adapted to the power of the pump unit (1540W).
How to fix Wave Hot Tub bubble system that does not work?
If the bubble system in your Wave Hot Tub isn't working, the pump may be overheating; cut off the power and wait for it to cool down. Also, the auto shut-down feature might be activated (after 30 minutes); press the bubble button to reactivate it.
Why water filtration does not work in Wave Hot Tub?
If the water filtration in your Wave Hot Tub isn't working, start by checking the filter cartridge; it probably needs cleaning or replacing. Also, inspect the inlet and outlet for any blockages and clean them if necessary. Insufficient water level may cause air to get inside the pump, so ensure the water is filled to the minimum level.
Guidance on choosing a suitable, level, and safe location for installing the spa.
Instructions for testing the Residual Current Device (RCD) plug for electrical safety.
Step-by-step guide on how to assemble and inflate the inflatable spa.
Overview and explanation of the spa's control panel and its functions.
A guide to diagnose and resolve common problems encountered with the spa.
To Next Page
General
