Scheps Omni Channel / User Guide
Channel Strip Modules
Pre Module
The Pre module is used primarily to add harmonic distortion, much like analog devices add odd or even harmonics,
or clipping, to a signal. The name “Pre” suggests the type of harmonic distortion that one would normally associate
with driving preamps. But don’t be misled by this module’s default position at the beginning of the chain. Think of it
instead as a processor that adds warmth and color that can be located at any point in the signal path. At the heart of
the module is the Saturation section, which controls the type and amount of added harmonic distortion. There are
also HP/LP filters and an EQ that adds a gentle low-frequency “thump” or resonance.
Thump on/off and gain
select
To Next Page
Loading...
Need help?
General
