Waves Scheps Omni Channel User Manual

Scheps Omni Channel / User Guide
41
Master Module
The VU Meter section has three metering sources: plugin input, plugin output, and total gain
reduction. This selection affects VU meters only. It does not affect full-scale meters or audio
output.
Use the meter trim pot on the right to align the meters to a reference tone.
Range 4 dB to 26 dB.
Use the Monitor section (stereo component only) to select how audio is monitored. Options
are: stereo or mono, left or right, mid or side. This selection is reflected in the VU meters and
the Output full scale meters.
The Limiter is an adjustable brickwall limiter that is positioned just before the plugin’s output.
Lower the Limit setting significantly and you will likely hear distortion.
Limiter Range: -30 dB to 0 dB
Full-scale Input and Output Meters are at the bottom of the module. Link the left and right
input faders or output faders with the Link button at the bottom. When faders are unlinked, you
can establish an offset between left and right faders, and then relink them. The offset between
the two faders will be maintained as they move.
Clipping is indicated at the top of the meter and peak level hold is at the bottom. Click on the
meter to clear all indicators.

Waves Scheps Omni Channel Specifications

General

Brand	Waves
Model	Scheps Omni Channel
Category	Recording Equipment
Language	English