Webasto BlueCool Classic

BlueCool Unit Performance Report
49
Controller settings
Main menu
Function Description AC AH 1 AH 2 AH 3 AH 4
.. Room temperature
.. Setpoint temperature
b.. Fan speed
H / E.. Temperature
F.. Cycle mode
U.. Line current
1C.. Compressor 1 on/off
2C.. Compressor 2 on/off
3C.. Compressor 3 on/off
4C.. Compressor 4 on/off
P.. Compressor sequence
L.. Start delay compressors
1L.. Temp. comp. 1 off
2L.. Temp. comp. 2 off
3L.. Temp. comp. 3 off
4L.. Temp. comp. 4 off
d… Dehumidifying
t… Display time
S… Choice of chilled water temperature
sensor outlet or inlet
c… Temperature difference between
compressor starts
E… Max temperature difference between
chilled water outlet and inlet
29 °C menu
0 Temp. low cut-out
1 Temp. low cut-in
2 Temp. high cut-out
3 Temp. high cut-in
4 Calibration H/E temp. sensor
5 Time [min] to sleep mode
6 Start delay unit
7 Calibration room temp sensor
8 Calibration AC 50 Hz
9 Setting R2
A Calibration AC 60 Hz
b Software version
c Lower cut-out value in cool mode for
chilled water temperature inlet
d Cut-in value in cool mode for chilled
water temperature inlet
E Higher cut-out value in heat mode for
chilled water temperature inlet
F Cut-in value in heat mode for chilled
water temperature inlet