EasyManua.ls Logo

Webasto DBW 2016 - Suggestions for Improvement and Change

Webasto DBW 2016
78 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1Introduction DBW 2010 / 2016
104
All fuel tanks offered in the Webasto accessories catalogue
are individually subjected to a pressure test of at least 0.3 bar
gauge pressure at the factory.
The respective operating mode of the heater, at least
switched on or off, must be easily recognisable.
For heaters in vehicles not subject to the German Road Vehicle
Licensing Act (StVZO), approval by the respective test facility
is required – provided there are applicable regulations.
1.7 Suggestions for improvement and
change
Complaints, improvements or suggestions for correction to
this technical manual should be directed to Webasto.
Visit www.butlertechnik.com for more technical information and downloads.
www.butlertechnik.com

Table of Contents

Other manuals for Webasto DBW 2016

Related product manuals