Webasto MVS400 User Manual (English)

Other manuals for Webasto MVS400

Questions and Answers:

S
susanvaughnAug 8, 2025
What to do if Webasto MVS400 Battery Charger does not start the charge?
- K
  kristin10Aug 8, 2025
  If the Webasto Battery Charger does not start charging when the battery is connected, it could be due to several reasons: * The output connector might not be fully connected. * The BMID could be faulty or reading out of range. * The pilot line might be disconnected. * The control board could be bad. * The signal wiring may be loose or incorrect. * There might be corrosion on the signal pins. * The battery could be over-discharged. You should consider checking the connections, BMID, pilot line, control board, wiring, and for corrosion. The suggested solution is F G F B F EE K.
M
Mary BirdAug 13, 2025
Why does Webasto MVS400 stop before the charge is completed?
- K
  Kevin KlineAug 13, 2025
  If your Webasto Battery Charger stops before the charge is completed, it could be due to several factors: * The battery is overheating. * The communication line is lost. * A cell within the battery pack is bad. * There is an algorithm/capacity mismatch. * The charger itself is overheating. * The BMID configuration is incorrect. The suggested solution is H, P F I J AA J.
S
Samantha AdamsAug 18, 2025
Why the display or LEDs do not illuminate on Webasto Battery Charger?
- S
  Sandra ClarkeAug 18, 2025
  If the display or LEDs on your Webasto Battery Charger do not illuminate, it could be due to the following reasons: * There is no AC power to the charger. * The AC input is mis-wired. * The 120-VAC input fuse is blown. The suggested solution is D D C.