EasyManua.ls Logo

Weber SPIRIT E220 - Page 27

Weber SPIRIT E220
84 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WWW.WEBER.COM
®
27
ANNUAL MAINTENANCE
BURNER TUBE CLEANING
OR REPLACEMENT (continued)
Reinstall Burner Tubes
For Spirit
®
grills with 2 burners (210 and 220 models):
A) Put burner tube 2 inside cookbox and pass the front
end of tube out through burner tube 2 opening. Note:
Single row of burner ports should be facing up. Slide
burner tube 2 under the guide screw and washer(1).
B) Put burner tube 1 inside cookbox and pass igniter
wires and the front end of tube out through burner
tube 1 opening(2). Guide wires from burner tube 1
between front cross brace and cookbox and down into
cabinet(3).
C) While holding burner tube 1, insert left side of
Crossover
®
tube into Crossover
®
burner hole(4).
Guide right side of Crossover
®
tube into Crossover
®
burner hole in burner tube 2 (not pictured). Note: The
Crossover
®
tube burner ports should face the front of
the cookbox.
D) Slide burner tube 1 under the guide screw and
washer(5).
For Spirit
®
grills with 3 burners (310 and 320 models):
A) Put burner tube 2 inside cookbox and pass the front
end of tube out through burner tube 2 opening(1).
Note: Single row of burner ports should be facing up.
B) Slide Crossover
®
tube alignment guide over the end of
burner tube 2 (2). Note: The Crossover
®
tube burner
ports should face the front of the cookbox. With
Crossover
®
tube attached, slide burner tube 2 under
the guide screw and washer(3).
C) Put burner tube 3 inside cookbox and pass the front
end of tube out through burner tube 3 opening (not
pictured). Insert right side of Crossover
®
tube into
Crossover
®
burner hole in burner tube 3. Slide burner
tube 3 under the guide screw and washer(4).
D) Put burner tube 1 inside cookbox and pass igniter
wires and the front end of tube out through burner
tube 1 opening (5). Guide wires from burner tube 1
between front cross brace and cookbox and down into
cabinet(6).
E) While holding burner tube 1, insert left side of
Crossover
®
tube into Crossover
®
burner hole. Slide
burner tube 1 under the guide screw and washer(7).
6
3
5
2
1
5
4
2
1
7
3
4

Table of Contents

Related product manuals