8 WWW.WEBER.COM
IMPORTANT INFORMATION ABOUT LPG CYLINDER CONNECTIONS
WHAT IS A REGULATOR?
Your WEBER gas barbecue
is equipped with a pressure
regulator, which is a device
to control and maintain
uniform gas pressure as gas is
released from the LPG cylinder.
REPLACEMENT HOSE,
REGULATOR AND VALVE ASSEMBLY
m IMPORTANT NOTICE:
We recommend that you replace the
gas hose assembly on your WEBER
gas barbecue every five years. Some
countries may have requirements that
the gas hose be replaced within less
than five years, in which case that
country’s requirement would take
precedence.
For replacement hose, regulator, and
valve assemblies, contact the Customer
Service Representative in your area
using the contact information on our
web site.
Log on to www.weber.com.
REGULATOR CONNECTIONS
Your Weber gas barbecue is equipped with a pressure
regulator, which is a device to control and maintain
uniform gas pressure as gas is released from the LPG
cylinder. Each pressure regulator is designed for vapor
withdrawal.
• The pressure regulator supplied with the Weber gas
barbecue must be used. This regulator is set for
2.75kPa.
• Replacement pressure regulator and hose
assemblies must be those specified by Weber-
Stephen Products LLC.
• Be sure the regulator is mounted with the small vent
hole pointed downward so that it will not collect water.
This vent should be free of dirt, grease, bugs, etc.
m WARNING: Replacement LPG cylinders
must match the regulator connection
supplied with this Weber gas appliance.
E-310 PREMIUM DIMENSIONS
116 cm
81.3 cm
61 cm
Gas Connection
Right Side of Barbecue
REGULATOR CONNECTION
1
2
3
5
4
1 Valve
2 Handwheel – close clockwise
3 External Thread
4 Thermally Sensitive Nut – tighten clockwise
5 Regulator Vent Hole
To Next Page
Loading...
