1) Open the lid.
2) Make sure all burner control knobs areturned off. (Pushcontrol knob in and turn
clockwise to ensure that it isin the 'OFF' position.)
/k WARNING:The burner control knobs must be in the "OFF"
position before turning on the liquid propane cylinder tank
valve. If they are not in the "OFF" position, when you turn on
the LP cylinder valve, the "excess gas flow control" feature
will activate, limiting the flow of gas from the LP cylinder. If
this should occur, turn off the LP cylinder valve and burner
control knobs. Then start over.
ARRETE EN MARCHE
OFF O O ON
APAGADO ENCENDIDO
; $
Ak DANGER
When the "excess gas flow control" feature is activated,
a small amount of gas is still flowing to the burners. After
turning oft the cylinder and burner control knobs, wait at
least 5 minutes for the gas to clear before attempting to light
the grill. Failure to do so may result in an explosive flare-up,
which can cause serious bodily injury or death.
3) Turn the cylinder on by turning the cylinder valve counterclockwise.
Ak WARNING: Do not lean over the open barbecue,
4) Ignite each adjacent Sear Station" rnain burner. Push the control knob in and turn
to "START/HI" until you hear the igniter snap - continue to hold control knob in for
two seconds. This action will spark the igniter, the burner lighting tube and then
main burner.
5) Check that the burner is lit by looking through the cooking grates. You should see
a flame. It burner does not light on first try, push control knob in and turn to OFR
Repeat lighting procedure a second time.
To ignite the Sear Station" burner continue with Step 6.
SearBurnerLighting: Ignition byan ad/acent ignited MainBurner
6) TurnSearStation"burnercontrolknobtotheONposition.
7) Verityburnerignition by visual inspection ofaflame.
Ak WARNING: If ignition does not occur in 5 seconds, turn
burner control OFF, wait 5 minutes, and repeat steps 6 & 7,or
see Match Lighting instructions.
A', WARNING: If the burner still does not light, turn the burner
control knob to "OFF" and wait 5 minutes to let the gas clear
before you try again or try to light with a match.
Note: See Maintenance top burner removal and cleaning
procedure.
TO EXTINGUISH
Push in and turn each burner control knob clockwise to "OFF" position. Turn gas supply
off at the source.
SEAR STATION" BURNER LIGHTING
*The grill illustrated may have slight
differences than the model purchased.
® ®
w w
To Next Page
Loading...
