USINGTHESEARSTATION"
Your Weber e gas barbecue includes a sear burner for searing meats such as steak,
poultry parts, fish. and chops).
Searing is a direct grilling technique which browns the surface ot the food at a high
temperature. By searing or browning both sides of the meat you will create a more
desirable flavor by caramelizing the food surface. Searing will also enhance appearance
of the meat with sear marks from the cooking grates. This along with the contrast of
textures and flavors can make food more interesting to the palate
The Sear Station" burner has an on or off control setting that works with the two
adjacent main burners. With the sear and adjacent burners you can effectively sear
meats while using other cooking areas for grilling with moderate heat.
TO USE THE SEAR STATION TM
Before searing you should turn all of the main burners on HI for 15 minutes to preheat
the grill. Note: Always grill with the lid closed to allow for maximum heat and to avoid
11areups.
Once the grill is preheated, turn the outer burners off or down to low. Leave the center
two burners on HI and ignite the Sear Station Burner (See Sear Station TM lighting
Instructions).
Place the meat directly over the Sear Station". You will Sear each side anywhere from
1 to 4 minutes, depending on the type of meat and thickness.You may turn the food a
quarter turn to make crossing sear marks (1) before you sear the other side in the same
manner.
Once you are done searing you can finish grilling by moving the meat to a more
moderate heat over the outside burners to achieve the desired aloneness.
As you gain experience in using your Sear Station TM, we encourage you to experiment
with different searing times to find results that work best for your taste.
SEAR STATION TM BURNER LIGHTING
Summary lightinginstructions are inside the left hand cabinet door.
,4',DANGER
Failure to open the lid while igniting the barbecue's burners,
or not waiting 5 minutes to allow the gas to clear if the
barbecue does not light, may result in an explosive flame-up
which can cause serious bodily injury or death.
6 burner
0 O 0 0 O 0
3 4
Sear Method
_od is placed inth_ area of intense heat between th_ ht bumef_
®
The Sear Station" burner has an on or off control seliing. To ignite the Sear StationTM
burner you mustfirst ignite the two adjacent main burners.
ADJACENT MAIN BURNER SNAP IGNITION
Note: Each main burner control knob snap igniter creates a spark from the igniter
electrode to the burner lighting tube Yougenerate the energy for the spark by pushing
inthe control knob and turning to "START/HI:ThIs will ignite each individual burner
/I', WARNING: Check hose before each use of barbecue for
nicks, cracking, abrasions or cuts. If the hose is found to
be damaged in any way, do not use the barbecue, Replace
using only Weber _ authorized replacement hose. Contact
the Customer Service Representative in your area using the
contact information on our web site. Log onto www.weber.
com e.
To Next Page
Loading...
