PROBLEM CHECK CURE
Burners burn with a yellow or orange Inspect Spider/Insect Screens for possible Clean Spider/Insect Screens. (See Section 'Annual Maintenance")
flame, in conjunction with the smell obstructions. (Blockage of holes.)
of gas (This is normal for the burner
fighting tube).
Sear Station burner does not light. Did you ignite the two adjacent main burners Verify adjacent main burner ignition by visual inspection of a flame.
(See Sear Station TM burner lighting instructions A WARNING: If Ignition does not occur in 5 seconds, turn burner control
for safe lighting procedure)
OFF, wait 5 minutes to let the gas clear before you try again
Does Burner light with a match? If you can light Burner with a match, then check the Crossove¢ _Channel on the sear
burner. (See Maintenance for burner removal and cleaning procedure)
Does the igniter work (Do you see a spark Try manually lighting the burner (refer to "Lighting the Rotisserie Burner"). Call
when you repeatedly use the snap igniter? customer service.
General Symptoms: The excess flow safety device, which is part of To reset the excess flow satefy device turn all burner control knobs and the cylinder
Burner does not light. -or- Burner has the barbecue to cylinder connection, may have valve to "OFF'.' Disconnect the regulator from the cylinder.Turn burner control knobs
a small flickering flame activated, to "START/HI';Wait at least 1 minute. Turn burner control knobs to "OFF': Reconnect
the regulator to the cylinder. Turn cylinder valve on slowly. Refer to "Lighting
Instructions';
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com ®.
OPERATING THE HANDLE LIGHT
The Weber Grill Out TM Handle Light has a built-in "Tilt Sensor." With the power button (a)
activated, the light will come on when the grill lid is open. The light will turn off when the lid
is closed. For daytime use. deactivate the sensor by pressing power button (a).
PROBLEM
Weber Grill OutTM Handle
Light does not light.
CHECK
Are the batteries old?
Are the batteries installed correctly?
Is the lid in the up position with the power button ON?
Is the Weber Grill Out TM Handle Light activated?
Is the Weber Grill Out" Handle Light positioned correctly on the handle?
CURE
Replace batteries.
See assembly illustration.
Light will activate when lid is open.
Press the power button.
Adjust position (See assembly illustration).
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com ®.
Ak ATTENTION:This product has been safety tested and is only certified for use in a specific country. Refer to country
designation located on outer carton.
These parts may be gas carrying or gas burning components. Please contact Weber-Stephen Products Co., Customer Service Department for genuine Weber-
Stephen Products Co. replacement part(s) information.
A', WARNING: Do not attempt to make any repair to gas carrying or gas burning components without contacting Weber-Stephen
Products Co., Customer Service Department.Your actions, if you fail to follow this product Warning, may cause a fire or an
explosion resulting in serious personal injury or death and damage to property.
To Next Page
Loading...
