HMI and Basic Programming
CFW501 | 4-3
4
4.3 OPERATING MODES OF THE HMI
The monitoring mode allows the user to view up to two variables of interest, one on the main display, and another
on the secondary display. Such fields of the display are defined in Figure 4.2: Display areas on page 4-2.
Level 1 allows the user to select the menu items to direct the browsing of the parameters.
Level 2 allows browsing the parameters of the group selected by level 1.
Level 3, in turn, allows the modification of the parameter selected in level 2. At the end of this level, the modified
value is saved or not if the key ENTER or ESC is pressed, respectively.
The Figure 4.3: HMI operating modes on page 4-3 illustrates the basic browsing of the operating modes of the HMI.
Monitoring Mode
It is the initial status of the HMI after the powering up and of the initialization
screen, with factory default values.
The field menu is not active in this mode.
The main display and secondary display of the HMI indicate the values of
the two parameters preset by P0205 and P0206.
From the monitoring mode, when you press the ENTER/MENU key, you
commute to the setting mode.
Monitoring
Parameterization
Level 1
Parameterization
Level 2
Parameterization
Level 3
BACK
ESC
BACK
ESC
BACK
ESC
ENTER
MENU
ENTER
MENU
ENTER
MENU
Setting Mode
Level 1:
This is the first level of the setting mode. It is possible to choose the
parameter group using the keys and .
The fields: main display, secondary display, bar graph for monitoring of
variable and measurement units are not shown in this level.
Press the ENTER/MENU key to go to level 2 of the setting mode – parameter
selection.
Press the BACK/ESC key to return to the monitoring mode.
Level 2:
The number of the parameter is shown on the main display and its content
on the secondary display.
Use the and keys to find the desired parameter.
Press the ENTER/MENU key to go to level 3 of the setting mode- modification
of the parameter content.
Press the BACK/ESC key to return to level 1 of the setting mode.
Level 3:
The content of the parameter is shown on the main display and the number
of the parameter is shown on the secondary display.
Use the and keys to configure the new value for the selected
parameter.
Press the ENTER/MENU key to confirm the modification (save the new
value) or BACK/ESC to cancel the modification (not save the new value).
In both cases, the HMI returns to level 2 of the setting mode.
Figure 4.3: HMI operating modes
NOTE!
When the inverter is in the fault state, the main display indicates the number of the fault in the format
Fxxxx. The browsing is allowed after pressing the ESC key, and the indication Fxxxx goes to the
secondary display until the fault is reset.
NOTE!
When the inverter is in the alarm state, the main display indicates the number of the alarm in the
format Axxxx. The browsing is allowed after pressing any key, and the indication Axxxx goes to
the secondary display until the situation causing the alarm is solved.
To Next Page
Loading...
Need help?
General
