Wega Atlas 2010 User Manual

USER manual
50 of 216
NERO
C:0 M:0 Y:0 K:100
ROSSO
C:0 M:100 Y:100 K:0
VERDE
C:100 M:0 Y:100 K:0
6.6.4 EVD version
PROGRAMMING
The machine is programmed
by default. Should the coffee
doses need to be modied, pro-
ceed as follows:
• Always programme the right
hand push-button panel rst.
In this way all push-button
panels get automatically pro-
grammed. If necessary, sub-
sequently programme the
others;
• place the programming le-
ver (X) (See note *) located
under the boiler cover of the
machine, in the ON position;
• put the coee cup under the
dispensing spout;
• press button
for at least
5 seconds, until all leds of the
dose buttons are lit;
• press the wanted dose but-
ton, for example
;
• to confirm the dose, press
button
;
• repeat this operation for the
other dose buttons;
• when nished programming,
return the programming lever
(X) (See note *) to the OFF
position.
Programming of every dose must be carried out with ground coee
and not with previously used coee dregs.
X
NOTE (
*
)
• In some models, there is no programming lever X; to
access programming, press the key
for at least 5
seconds with all push button panel LED on. To con-
rm the dose press the
key or the selected dose
key again.
• In other models, to access programming it is neces-
sary to use a special key switch.
• To exit programming it is sucient to wait a few
seconds.
EXAMPLES OF PUSH BUTTON PANELS INSTALLED ON THE MACHINES
COFFE DISPENSING
• Put the coee cup under the
dispensing spout;
• press the desired dose key, for
example
and wait for the
coee to be dispensed (LED
comes on);
• to block the dispensing of
coee in advance, press but-
ton
again or button ;
• in the event of anomalies or
if the push button panel is
locked, use the manual switch
(see EPU version).
Do not remove the lter-holder from
the delivery group during coffee
dispensing

Wega Atlas 2010 Specifications

General

Brand	Wega
Model	Atlas 2010
Category	Coffee Maker
Language	English