Wega Atlas 2010 User Manual

USER manual
52 of 216
NERO
C:0 M:0 Y:0 K:100
ROSSO
C:0 M:100 Y:100 K:0
VERDE
C:100 M:0 Y:100 K:0
6.9 Manual dispensing of hot water
• Place the jug under the hot water
spout;
• rotate the tap knob clockwise;
• the dispensing of hot water will
be proportional to the opening
of the tap;
• to complete the dispensing,
rotate the tap knob clockwise.
Avoid contact with the hot water nozzle, do
not direct your hands or other body parts
towards the hot water nozzle ends.
6.10 Automatic dispensing hot water
PROGRAMMING
The machine is programmed
by default. Should the doses
need to be modied, proceed
as follows:
• Move the programming
lever X (see note *) located
under the body RH front
panel, to the ON position;
• position the jug under the hot
water spout;
• press the
key for at least 5
seconds until all dose key LED are
on;
• press the hot water dispensing
button (Y);
• to conrm the dose press but-
ton
;
• on concluding the program-
ming, return the programming
lever X (see note*) to the OFF
position.
NOTE (
*
)
• In some models the program-
ming lever X is not tted; to enter
the programming mode, press
button
for at least 5 seconds,
with all push-button panel leds
switching on. To conrm the dose
press
.
• In other models, to access
programming it is necessary
to use a special key switch.
• To exit programming it is suf-
cient to wait a few seconds.
Y
Y X

Wega Atlas 2010 Specifications

General

Brand	Wega
Model	Atlas 2010
Category	Coffee Maker
Language	English