Wega Atlas 2010 User Manual

USER manual
48 of 216
NERO
C:0 M:0 Y:0 K:100
ROSSO
C:0 M:100 Y:100 K:0
VERDE
C:100 M:0 Y:100 K:0
6.4 Renewing the water
During the installation of the machine, the Qualied
Technician must replace the water contained in the hy-
draulic circuits by following these steps:
• when installation is complete, the appliance has to
be started, brought to the nominal working condi-
tion and left for 30 minutes in the "ready to operate"
condition;
• afterwards, the appliance has to be turned o and
emptied of the rst water introduced in the whole hy-
draulic circuit, to eliminate possible initial impurities;
• following this, the equipment must be charged again
and taken to its nominal operating conditions;
• After having reached the “ready for operation” status,
the following dispensing actions must be carried out:
- for each coee unit, carry out a continuous deliv-
ery, in order to release at least 0.5 litres from the
coee circuit. In the case of several dispensing
points matched with the same exchanger/coee
boiler, divide the volume on the base of the num-
ber of the dispensing points;
- discharge the whole volume of hot water from
the boiler (3 litres for 1GR, 6 litres for 2GR, 8 litres
for 3GR, 11 litres for 4GR) continuously dispensing
from the specic spout. In case of multiple dis-
pensing points, subdivide this volume according
to the number of dispensing points;
- continuously release steam for at least 1 minute
for each steam dispensing point.
If the machine remains inactive for a time longer than 1 week, the
Qualied Technician must renew 100% of the water contained in
the hydraulic circuit, as indicated above.
6.5 Preparing the machine
6.5.1 Coee grinding and dosing
It is important to have a dosing-grinding device next
to the machine with which to grind the coee to use
daily.
The grinding and the dosing of the coee must be
done according to that indicated by the manufacturer
of the dosing-grinding device. The following points are
also to be kept in mind:
• to obtain a good espresso it is recommended not to
keep large stocks of coee grains. Observe the expiry
date indicated by the producer;
• never grind large volumes of coee, it is advisable to
have the quantity contained in the dosing device and
to use it if possible by the end of the day;
• If possible, never purchase already ground coee,
as it deteriorates quickly. If necessary, buy it in small
vacuum-sealed packages.
6.5.2 Preparing the lter holder
• Fill the lter with a dose of ground coee (circa 6-7
gr.) and press it with the press;
• hook the lter-holder to the unit without closing it too
tightly in order to avoid excessive wear of the gasket;
• for the same reason it is recommended to clean the
edge of the lter before attaching the lter holder to
the dispensing unit;
• follow the procedures specied by the manufacturer
of the grinder.
6.5.3 Switching on of the work top light (if tted)
To switch on the light of the machine enclosure, press
the switch located under the controls front panel.
To switch the light o, select the same switch again.

Wega Atlas 2010 Specifications

General

Brand	Wega
Model	Atlas 2010
Category	Coffee Maker
Language	English