USER manual
58 of 216
NERO
C:0 M:0 Y:0 K:100
ROSSO
C:0 M:100 Y:100 K:0
VERDE
C:100 M:0 Y:100 K:0
• to activate the wash, press button 2 again (buttons
1 and 2 ashing - in the versions with display the fol-
lowing message is shown:
UNIT WASHING
IN PROGRESS
• wait for the complete sequence of 5 automatic wash-
ing cycles to be completed (about 1 minute);
• At the end of the rst washing cycle, indicated by
the led ashing on button 2, remove the blind lter
carrier from the unit;
• start the rinsing cycle pressing button 2 (ashing of
buttons 3 and 4 - in the versions with display the fol-
lowing message is shown:
UNIT WASHING
IN PROGRESS
• wait for the complete automatic rinsing cycle to end
(about 1 minute);
• at the end of the rinsing cycle the machine is ready
for normal use.
The washing of multiple units simultaneously is possible: each
keypad controls its specic unit.
Should the electrical power be cut o during a washing or rinsing
stage, when switched on, the machine will propose again the
washing of the unit. The operation to eliminate the possible
presence of residual detergent in the unit must be carried out
again.
Do not carry out the washing of the unit in case of the AL version.
7.5.6 Perforated disk cleaning
Weekly perform the cleaning of the perforated disk
in the following way:
• Remove the seal (1) by
levering it with a screw-
driver, being careful not
to damage it;
• remove the perforated
disk (2) and wash it with
hot water;
• place the perforated disk
and seal back to the original position.
7.5.7 Cleaning of the steam spout
On a weekly basis, carry out the steam spout clean-
ing as follows:
• Immerse the spout in a jug with water and a specic
detergent according to manufacturer's instructions;
• heat the solution with the steam of the spout;
• let the spout cool o keeping it
immersed in the solution for at
least 5 minutes to allow the de-
tergent to rise inside the spout by
cooling eect;
• repeat the operation 2 or 3 times
until milk is delivered.
1
2
To Next Page
Loading...
Need help?
General
