Weider Pro 2250 - User Manual

Questions and Answers

R
rrodgersJul 31, 2025
What to do if Weider Pro 2250 cables have slack before resistance is felt?
- A
  Amanda ScottJul 31, 2025
  To fix cables that have slack before resistance is felt in your Weider Home Gym, you can try the following: * Tighten the cables by moving the 3 1/2” Pulley to the lower hole in the Long “U”-bracket. * Remove the 3/8” Nylon Locknut and the 3/8” x 2” Bolt from the Cable Trap, Pulley, and “U”-bracket and then re-attach the Pulley and Cable Trap. * Tighten the 1/4” Nylon Locknuts at the end of the Long Cable and at the end of the Short Cable. * Remove the Small “U”-bracket from the Weight Tube or remove the 3 1/2” Pulley from the Long “U”-bracket.
K
kylewilliamsAug 9, 2025
How to tighten slack cables on Weider Pro 2250 Home Gym?
- R
  Richard PattonAug 9, 2025
  To address slack in the cables of your Weider Home Gym before resistance is felt, several adjustments can be made: * First, ensure the cables are properly tightened. * Second, consider relocating the 90mm Pulley (15) to the lower hole in the Long “U”-bracket (57). You should remove the M10 Nylon Locknut (21) and the M10 x 48mm Bolt (12) from the Cable Trap (66), Pulley, and “U”-bracket, then re-attach the Pulley and Cable Trap. * Finally, check and tighten the M8 Nylon Locknuts (3) located at the end of the Long Cable (23) or the Short Cable (58).
R
Robert MooreAug 18, 2025
What to do if cable slips off pulleys on Weider Home Gym?
- G
  greencharlesAug 19, 2025
  If the cable on your Weider Home Gym frequently slips off the pulleys, the immediate solution is to remove the cable and then carefully reinstall it, ensuring it is properly seated within the pulley grooves.