Weider PRO 260 - Part Identification Chart

PART iDENTiFiCATiON CHART
Refer to the drawings below to identify small parts used in assembly. The number in parentheses by each draw-
ing is the key number of the part, from the PART LIST in the center of this manual. Note: Some small parts
may have been pre=attached, if a part is not in the parts bag, check to see if it has been pre=attached.
MIO Nylon Locknut (43)
@8
M8 Nylon Locknut (55)
M6 Nylon Locknut (51)
[
MIO Washer (44)
i : )
\
M8 Washer (56)
M6 Washer (48)
M4 x 16mm Screw (45)
MIO x 81mm Bolt (41)
MIO x 75mm Bolt (42)
MIO x 68mm Bolt (54)
MIO x 65mm Bolt (40)
MIO x 60mm Bolt (47)
M8 x 58mm Bolt (52)
M6 x 40mm Bolt (49)
MIO x 19mm Bolt (53)
D
M6 x 16mm Screw (39)