Weider PRO 260 - Page 6

AttachtheBenchFrame(1)totheFrontLeg(2)
withtwoMIOx65mmBolts(40),twoMIO
Washers(44),andtwoMIONylonLocknuts(43).
Donottightenthe Locknuts.
AttachtheBenchFrame(1)totheCrossbar(4)
withtwoMIOx81mmBolts(41)andtwoMIO
NylonLocknuts(43).
TightentheIVll0 Nylon Locknuts (43) used in
steps 1 through 3.
Attach the Weight Tube (16) inside the Leg Lever
(3) with an M8 x 58mm Bolt (52), two M8
Washers (56), a lOmm Spacer (32), and an M8
Nylon Locknut (55).
Press the 25mm Round Angled Cap (28) onto the
Weight Tube (16).
Grease an MIO x 68mm Bolt (54). Attach the Leg
Lever (3) with the Bolt and an MIO Nylon Locknut
(43). Do not overtighten the Locknut; the Leg
Lever must be able to pivot easily.
Orient the Backrest Frames (12) with the indicat-
ed holes closer to the bottom. Attach the Backrest
Frames to the Backrest Bracket (10) with four M6
x 40mm Bolts (49), four M6 Washers (48), and
four M6 Nylon Locknuts (51). Do not tighten the
Locknuts.
44
4O
40
J
4
43
41
567
16 52
_rease
6