WEIHONG NK105 G2F - Page 70

Specialized Concentrated Focused
「58」References
Parameter
Meaning
Setting range
REFP Dir
The direction of rough positioning in backing to
machine origin
Positive; Negative
Retract Dist
The additional motion distance after fine positioning
stage in backing to machine origin, to move out of the
machine origin signal sensitive zone
0~10000 mm
Sign of BK REF
Whether to eliminate the sign of backing to machine
origin after E-stop
Yes: Eliminate
No: Not eliminate
CAUTION
If you can ensure that the axis position will not deviate after E-stop, you can set the parameter “Sign of BK REF”
to “No”, so you can continue machining without backing to machine origin after E-stop is obviated. Otherwise,
you need to set this parameter to “Yes” to ensure machining accuracy.
 Spindle Parameters
Parameter
Meaning
Setting range
Spindle Set
ON/OFF Delay
The wait time for the spindle to reach normal rotary
speed or stop completely after turned ON or OFF
0~60000 ms
Spindle Speed
The spindle speed during auto machining
0~[Max. Spdl Speed]
Max. Spdl Speed
Max. spindle speed
Spindle speed~999999
mm/min
 Parameters Related with Y Rotary Axis
Parameter
Meaning
Setting range
Y AsRotaryAxis
Whether Y axis is set as rotary axis
Yes: Valid; No: Invalid
Rotary Y Pulse
The pulse equivalent of Y axis when it is set as
rotary axis
0~100 mm/p
mm As Unit
It sets the measure unit for the rotary axis.
Yes: in mm
No: in deg
Rev. WorkRadius
The length of Y axis in CAM programming is the
value of workpiece radius × 2× 
parameter changes with the radius of workpiece.
0~1000000mm
Rotary Takeoff
The takeoff speed of the rotary axis
0~1000000 mm/s
Rotary Y Acc.
The acceleration of the rotary axis, with unit as
rad/s
2
0.001~100000.0 rad/ s
2
Max. RotaryVel.
Max. rotary speed
0.06~6000000 r/min
 Parameters Related with Lubrication Setting
Parameter
Meaning
Setting range
EnableAutoLube
Whether to open lubrication pump automatically at
Yes: Valid