Merrychef eikon
®
e2s service and repair manual
_______________________________________________________________________________________________________________________________
_______________________________________________________________________________________________________________________________
Equipotential bonding connection
M8 nut (not fitted to some country specific versions)
Electromagnetic Compatibility (EMC) Filters
Diode(s) (high voltage)
Fitted by two pozidriv (PZ2) screws
Steam Vent (Exhaust pipe)
Two EMC filters fitted, Heater & Microwave*
Wiring connected by M7 hex nuts
EMC filter to bracket by two M7 hex nuts
EMC filter bracket to base plate by two M7 hex nuts, slotted in
at the back.
* Three filters fitted to JP models. Two on the filter bracket and a
third to the left of the HV Transformer for the VFD supply (see
wiring diagram in section 7.2 for further information).
One high voltage diode
(1000W e2s variant)
Two high voltage diodes
(2000W e2s variant)
The steam vent exhausts steam from
the rear of the cavity to the cooling
duct and the rear outlet of the oven.
This must be checked for obstruction
and cleaned as required.
Fitted to the rear of the cavity with a
M7 hex nut.
To Next Page
Loading...
