RIGHT CLEAR/LEFT CLEAR
Figure 14A Figure 14B
The designated right
R
or left
L
memory location contains no data.
Either no data has been stored, or previously stored data has been erased.
See page 7 for information on storing and erasing data.
LOW BATT(ery)
Figure 15
The LOW BATT message indicates that the battery needs to be recharged.
All buttons are disabled to prevent inaccurate results due to inadequate
battery voltage. Normal operation may be restored by recharging the battery
or replacing the battery with a charged battery. Stored data is not lost when
the battery is removed.
NOTE: The battery must be removed if the MicroTymp2 Handle
is to be stored or placed anywhere other than in the powered
Printer/Charger for more than one month. Failure to do this can
result in damage to the MicroTymp2 Handle.
See Appendix C, “Maintaining the MicroTymp2 Equipment,” for instructions
on removing and recharging the battery.
12
-400 -200 0 200
2
0.5
0
1.0
1
GR
A
GR
C
PRESSURE - daPa
Ya - mmho
+200 Vea - cc
-400 -200 0 200
2
0.5
0
1.0
1
GR
A
GR
C
PRESSURE - daPa
Ya - mmho
+200 Vea - cc
-400 -200 0 200
2
0.5
0
1.0
1
GR
A
GR
C
PRESSURE - daPa
Ya - mmho
+200 Vea - cc
To Next Page
Loading...
Need help?
General
