F-60
Standards Compliance
ETL listed to comply with UL 2601
ETL listed to compy with CSA C22.2 No. 601-1
ETL listed to comply with IEC 601-1, Amendment 1
MicroTymp2 Handle:
Class I Equipment, Type BF
MicroTymp2 Printer/Charger:
Class I Equipment, Type B
FCC Part 15, Class A
This device complies with CFR 47 Part 15 Class A of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
CBC C108.8 M1983, Class A
This digital apparatus does not exceed the Class-A limits for radio
noise emissions from digital apparatus set out in the Radio Interfer-
ence Regulations of the Canadian Department of Communications.
The CE mark on this device indicates it has been tested
to and conforms with the provisions noted within the
93/42/EEC Medical Device Directive.
Authorized European Representative Address:
European Regulatory Manager
Welch Allyn, Ltd.,
Kells Road, Navan,
County Meath,
Republic of Ireland
Tel. 353 46 28122
Fax 353 46 28536
This instrument complies with the following standards based on the most
recent revision available at the time of design:
American National Standard for Instruments to Measure Aural Acoustic
Impedance and Admittance — Aural Acoustic Immittance; ANSI S.39-
1987 (ASA 71-1987)
ANSI Type 4 instrument
IEC — Instruments for the Measurement of Aural Acoustic Impedance/
Admittance; IEC 1027:1991
IEC Type 4 instrument
0050
To Next Page
Loading...
Need help?
General
