Welch Allyn Spot Vision Screener VS100 - Connecting a Device to the Network

Connecting a device to the network
1. Touch Tools, and then touch Network.
If the device is already configured with network settings, these display on the
bottom of the screen.
2. If the settings are correct, touch the X in the upper-left corner to return to the Tools
screen.
3. To connect a device to the network, add the network name (SSID) and security type.
For details, see the following sections.
To add/change the network name (SSID)
1. Touch within the SSID Name field.
The keyboard appears.
2. Enter the SSID (case sensitive network name).
3. Touch OK to save your changes and return to the previous screen.
To add/change the security type
1. Use the radio button to select the security type: WEP, WPA/2 PSK, or WPA/2 EAP-
PEAP.
2. Touch Passphrase.
The keyboard appears.
3. If you selected WPA/2 EAP-PEAP, enter the username and then select OK.
4. Enter the passphrase (or password) for your organization's network, and then select
OK.
5. On the Network screen, select OK to save the changes.
If you see... The vision screener is...
Successfully connected to your wireless network. The vertical bars indicate the strength of
the connection.
Not connected to the network. For tips on connecting to the network, refer to
Troubleshooting.
To enable or disable the wireless capability on the vision screener
Note If you disable the wireless capability, you must re-start the vision screener
to enable it again.
1. Touch Wireless On/Off .
2. Touch Enable or Disable.
26 Advanced settings on the vision screener Welch Allyn® Spot™ Vision Screener Model VS100