Weldclass Weldforce 202T - Remote Controls; Remote Control TIG Torch; Remote Foot Control (Optional Accessory)

Weldforce 202T AC/DC
© Weldclass 2020 | E.&O.E. 19
4.6 Remote Controls
4.6.1 Remote Control TIG Torch
The TIG torch supplied with the Weldforce 202T AC/DC machine incorporates a Remote Control
Amperage Potentiometer on the handle. This can be used to change the Main Amps either before or
during welding.
4.6.1 Remote Foot Control (Optional Accessory)
An optional Foot control is available for use with the Weldforce 202T AC/DC machine
(part no. WC-06370).
This enables the main current to be regulated by foot to allow the operator to change the amperage
whilst welding without compromising control of the torch.
Figure 10