EasyManua.ls Logo

WEMPE 20097 - Page 4

WEMPE 20097
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WEMPE digital main clock 20097
Table of contents
4
V3.0 01/2011
5.4.2 Fitting of cables at the console-mounting version ................................................. 19
5.5 Electrical connection................................................................................................... 19
5.6 Connection of secondary clocks ................................................................................. 20
5.7 Connection of GPS receiver........................................................................................ 20
5.8 Putting into operation.................................................................................................. 21
6 Operation......................................................................................................................... 22
6.1 Make basic settings .................................................................................................... 22
6.1.1 Unlock the keyboard............................................................................................. 22
6.1.2 Select indicated time............................................................................................. 22
6.1.3 Setting of time....................................................................................................... 22
6.1.4 Setting of date ...................................................................................................... 23
6.1.5 Setting of automatic time adjustment .................................................................... 23
6.1.6 Switching on/off and adjusting of display illumination............................................ 23
6.1.7 Lock the keyboard ................................................................................................ 24
6.2 Additional settings....................................................................................................... 24
6.2.1 Remove write protection for additional settings..................................................... 24
6.2.2 Setting of adjustment frequency for analogue secondary clocks........................... 25
6.2.3 Setting of impulse width........................................................................................ 25
6.2.4 Setting of analogue lines....................................................................................... 25
6.2.5 Setting of secondary clocks impulse voltage......................................................... 26
6.2.6 Setting of the internal standard interface............................................................... 27
6.2.7 Programming of relay outputs for error messages ................................................ 27
6.3 Set-up of secondary clocks......................................................................................... 27
6.4 Use of extension cards ............................................................................................... 28
6.4.1 Extension card for digital clocks............................................................................ 28
6.4.2 MOBALine extension cards .................................................................................. 28
6.4.3 Extension card for analogue clocks ...................................................................... 29
6.4.4 Serial extension card ............................................................................................ 30
6.5 Insertion of GPS receiver............................................................................................ 30
6.5.1 Select GPS receiver ............................................................................................. 30
6.5.2 Setting of baud rate .............................................................................................. 31
6.5.3 Synchronisation of the clock with GPS signal ....................................................... 31
6.5.4 Setting of synchronisation rate.............................................................................. 32
6.6 Programming summary............................................................................................... 33

Table of Contents

Related product manuals