WEMPE digital main clock 20097
Safety
V3.0 01/2011
9
2 Safety
All important safety aspects are summarized in this section for a safe and failure-free
operation of the unit.
The individual chapters contain in addition specific instructions marked by symbols.
Furthermore, the inscriptions on the unit need to be observed and should always be kept in
legible condition.
1.1 General information
The unit is designed and manufactured according to the state-of-the-art of good engineering
practice and is safe to operate.
However, the unit might represent a risk if it is not appropriately operated or not operated in
accordance with the regulations by persons lacking corresponding training.
Every person charged with the operation of the unit, shall read and understand the operating
instructions prior to operate the unit. We recommend the operator to request its staff to
confirm in writing that they are aware of the operating instructions.
Any kind of modification, alteration or extension of the unit is prohibited.
The indicated range of settings and operating conditions shall be kept.
1.2 Intended use
The safe operation is only guaranteed provided that the unit is used for its intended use and
according to the instructions.
The digital main clock 20097 is intended for the central control of secondary clocks and/or
secondary clock systems with impulses of 12V or 24V for the synchronised indication of time
and date.
ATTENTION! Material risk!
Any other use of the unit in excess of the intended use as described above
and/or differing form the intended use is prohibited and is regarded as improper
use.
Any kind of claim against the manufacturer and/or its agent due to loss or
damage resulting from improper use is excluded.
The operator is solely liable for any loss or damage due to improper use.
The proper and intended use also refers to the correct compliance with the instructions for
installation, operation and cleaning.
To Next Page
Loading...
