WEMPE 20097 - Page 57

WEMPE digital main clock 20097
Annex
V3.0 01/2011 57
A
Accessories ...........................................14
Accumulator...........................................14
Accumulator replacement ......................35
Additional circuit boards.........................14
Adjustment frequency for secondary
clocks.................................................25
Adjustment of display illumination ..........23
B
Basic settings ........................................22
Block diagram........................................39
C
Circuit boards ........................................40
Cleaning ................................................35
Connection of GPS receiver...................20
Connection of secondary clocks ............20
Console mounting..................................18
D
Design and function ...............................12
Display illumination on/off ......................23
Disposal...................................................8
E
Electrical connection..............................19
Explanation of the symbols ......................6
Extension cards .........................14, 28, 44
F
Fitting of cables......................................18
Front panel ............................................12
Front view..............................................12
Fuses.....................................................15
G
Guarantee................................................7
I
Insert GPS receiver ............................... 30
Installation....................................... 16, 17
Installation and operating staff............... 10
Intended use ........................................... 9
Interface protocols................................. 48
Interfaces .............................................. 11
L
Liability .................................................... 7
Lock the keyboard................................. 24
M
Maintenance.......................................... 35
O
Operation .............................................. 22
Operator’s responsibility ........................ 10
Oscillator ............................................... 11
Oscillator, readjustment......................... 36
P
Packaging ............................................... 8
Power reserve ....................................... 11
Power supply......................................... 11
Programming of relay outputs................ 27
Programming summary ......................... 33
Putting into operation............................. 21
Q
Qualified staff ........................................ 10
R
Remove write protection........................ 24
Requirements on the place of installation
.......................................................... 16