MAINTENANCE
1. Always use a dust collection system. This will help prevent sawdust from building up inside the band saw.
2. Wipe off the table after every use. Remove any pitch, sap, or resin that has accumulated on the table, blade guide,
bearings, etc. using a damp cloth.
3. At least once a month, open the doors and vacuum out any accumulated dust, shavings, etc. Remove the blade
and clean off any built-up sawdust from the wheels and tires using a stiff brush.
4. Check the drive belt at least monthly for proper tension and any signs of wear.
5. As needed, apply a light coat of good-quality paste wax to the table. This will help provide a smooth gliding sur-
face for your workpieces.
6. The bearings on your band saw are permanently sealed and lubricated, and require no additional lubrication.
7. If you do not plan to use the saw for a long period of time (over 1 week), release tension on the blade, as well as
on the drive belt. This will help prolong blade life and belt life. Do not forget to re-engage the belt and blade tension
before using the saw again.
WARNING! Always turn OFF and unplug the band saw before performing any maintenance.
Problem Possible Cause Solution
Saw is noisy.
Loose fastener.
Check the saw and stand and ensure that all fasten-
ers are tightened.
Guide bearings improperly
adjusted.
Adjust guide bearings properly (see sections on p.
13).
Improper blade tracking
setting.
Adjust tracking properly (see "ADJUSTING THE
BLADE TRACKING").
Blade is hitting something it
shouldn't.
Open up the saw doors and check to see if the blade
is hitting something (rotate wheels by hand).
Foreign object inside saw. Remove object.
Worn belt.
Replace belt. Contact customer service (1-800-232-
1195) for assistance.
Worn wheel or motor bear-
ing.
Remove blade. Rotate each wheel by hand, then
move the belt. Contact customer service (1-800-232-
1195) for assistance.
TROUBLESHOOTING GUIDE
WARNING! Stop using the generator immediately if any of the following problems occur or risk serious
personal injury. If you have any questions, please contact customer service at 1-800-232-1195 (M-F 8-5 CST),
or email techsupport@wenproducts.com.
17
To Next Page
Loading...
Need help?
General
