4
15. DO NOT OVERREACH. Keep proper footing and balance at all times. Wear oil-resistant rubber-soled foot-
wear. Keep the floor clear of oil, scrap, and other debris.
16. MAINTAIN TOOLS PROPERLY. ALWAYS keep tools clean and in good working order. Follow instruc-
tions for lubricating and changing accessories.
17. CHECK FOR DAMAGED PARTS. Check for alignment of moving parts, jamming, breakage, improper
mounting, or any other conditions that may affect the tool’s operation. Any part that is damaged should be properly
repaired or replaced before use.
18. MAKE THE WORKSHOP CHILDPROOF. Use padlocks and master switches and ALWAYS remove start-
er keys.
19. DO NOT operate the tool if you are under the influence of drugs, alcohol, or medication that may affect your
ability to properly use the tool.
20. USE SAFETY GOGGLES AT ALL TIMES that comply with ANSI Z87.1. Normal safety glasses only have
impact resistant lenses and are not designed for safety. Wear a face or dust mask when working in a dusty environ-
ment. Use ear protection such as plugs or muffs during extended periods of operation.
GENERAL SAFETY RULES
1. To avoid injury from unexpected movement, secure the machine to the floor before operating.
2. The machine must be switched off before inserting any material to be cut in the vise or before removing material
from the vice after cutting operations have been finished.
3. Keep your hands and fingers a safe distance away from the blade at all times.
4. Never attempt to stop the saw blade by hand.
5. Never remove any cutting chips by hand. Use a brush at all times.
6. Never remove any safety guards or safety equipment from the saw.
7. Never leave the machine during operation.
SPECIFIC RULES FOR BAND SAW
To Next Page
Loading...
Need help?
General
