Wen 3970 Manual

88
TO ASSEMBLE THE STAND
1. With the help of an assistant, lift the bandsaw onto a suitable support (Fig.A).
2. Attach the legs to the bandsaw with the M8-1.25 x 25 hex bolts, 8mm flat washers, 8mm lock washers and the
M8-1.25 hex nuts. Hand tighten.
3. Attach the short brace to the legs with the M6-1.0x16 carriage bolts, 6mm flat washers, 6mm lock washers and
M6-1.0 hex nuts. Hand tighten.
4. Lift the bandsaw onto the floor. Attach the long brace to the legs with M6-1.0 x 16 carriage bolts, 6mm flat
washers, 6mm lock washers and M6-1.0 hex nuts (Fig. B). Hand tighten.
5. Use the M6-1 x 12 hex bolts, M6-1 hex nuts, 6mm lock washers and the 6mm to install the wheel mounting
brackets to the legs (Fig. C). Hand tighten.
6. Slide the shaft through the holes in the wheel mounting bracket. Slide the wheels onto the shaft on the outside
of the mounting bracket and secure them with the cotter pins (Fig. D).
ASSEMBLY
Fig. A Fig. B
Fig. C Fig. D

Wen 3970 Specifications

General

Brand	Wen
Model	3970
Category	Saw
Language	English