UNPACKING
With the help of a friend or trustworthy foe, carefully remove the band saw from the packaging. Make sure to take
out all contents and accessories. Do not discard the packaging until everything is removed. Check the packing list
below to make sure you have all of the parts and accessories. If any part is missing or broken, please contact our
customer service at 1-800-232-1195 (M-F 8-5 CST), or email techsupport@wenproducts.com.
UNPACKING & PACKING LIST
WARNING! Do not plug in or turn on the tool until it is fully assembled according to the instructions. Failure
to follow the safety instructions may result in serious personal injury.
9
PACKING LIST
1. Band Saw (1)
2. Guide Rail (1)
3. Table with Insert (1)
4. Rip fence (1)
5. Short Brace (2)
6. Leg (4)
7. Long Brace (2)
8. Miter Gauge (1)
9. Accessory Tools (1)
10. Knob (4)
11. Hook with Hex Nut (1)
12. Push Stick (1)
Hardware Bag (Not Shown):
17. M8x12 Socket Head Bolts (8)
18. 8mm Flat Washers (12)
18. M6x12 Carriage Bolts (8)
20. 6mm Flat Washers (8)
21. M6 Hex Nut (8)
22. M4x10 Socket Head Bolts (2)
Circle Cutting Accessories:
13. Sliding Bracket
14. Center Pin
15. Lock Knob A
16. Lock Knob B
Tools Required for Assembly & Adjustments
The tools listed below are not included but are required for either assembly or adjustment.
• Two 13mm Open End Wrenches
• One Phillips Head Screw Driver
• One Combination Square
1
2
2
8
10
9
5
7
6
4
11
12
13
14
1615
To Next Page
Loading...
Need help?
General
