MAINTENANCE
ROUTINE INSPECTION
Before each use, inspect the general condition of the tool. If any
of these following conditions exist, do not use until parts are
replaced or the sharpener is properly repaired.
Check for:
• Loose hardware,
• Misalignment or binding of moving parts,
• Damaged cord/electrical wiring,
• Cracked or broken parts, and
• Any other condition that may affect its safe operation steady to
hold the cutterhead in place.
CLEANING & STORAGE
1. Keep the ventilation openings free from dust and debris to
prevent the motor from overheating.
16
Fig. 14
WARNING! To avoid accidents, turn OFF and unplug the tool from the electrical outlet before cleaning, ad-
justing, or performing any maintenance work.
WARNING! Any attempt to repair or replace electrical parts on this tool may be hazardous. Servicing of the
tool must be performed by a qualified technician. When servicing, use only identical WEN replacement parts.
Use of other parts may be hazardous or induce product failure.
1
2. Wipe the tool surfaces clean with a clean cloth. Make sure water does not get into the tool.
3. Store the tool in a clean and dry place away from the reach of children. Store in temperatures between 41° to 86°F.
4. Cover the miter saw in order to protect it from dust and moisture. It is preferable to store it in its original packag-
ing with the instruction manual.
CARBON BRUSH REPLACEMENT
Replacement carbon brushes (Part No. CM1452-035) can be ordered at wenproducts.com. Only genuine WEN re-
placement brushes designed specifically for your tool should be used.
1. To access the carbon brushes, remove the carbon brush cap (Fig. 14 - 1) with a flat-head screwdriver (not in-
cluded).
2. Carefully remove the old carbon brushes.
3. Install the new carbon brushes. Both carbon brushes should be replaced at the same time. Replace the carbon
brush cap.
NOTE: New carbon brushes tend to spark for a few minutes during the first use as they wear down.
PRODUCT DISPOSAL
Used power tools should not be disposed of together with household waste. This product contains electronic com-
ponents that should be recycled. Please take this product to your local recycling facility for responsible disposal and
to minimize its environmental impact.
To Next Page
Loading...
Need help?
General
