98
UNPACKING & TRANSPORTATION
UNPACKING
With the help of a friend or trustworthy foe, carefully remove the miter saw from the packaging. Make sure to take
out all contents and accessories. Do not discard the packaging until everything is removed. Check the packing list
below to make sure you have all of the parts and accessories. If any part is missing or broken, please contact our
customer service at 1-800-232-1195.
PACKING LIST
A. Miter Saw (1)
B. Support Stand (1)
C. 10mm/13mm Box-End Wrench (1)
D. Carbon Brush Replacement (2)
E. Clamp Assembly (1)
F. 6mm Hex Wrench (1)
G. Dust Collection Bag (1)
The tools listed below are not included but are required for either assembly or adjustment.
• Mounting Hardware
• Combination Square
• Phillips-head Screwdriver
TRANSPORTING THE MITER SAW
Before transporting your miter saw, make sure saw arm is locked down, the miter table is locked in position and
the slide lock knob is tightened. Only lift the saw by the carrying handle located on top of the belt housing or at the
back of the rails. Do not lift the saw using the guards or the operating handle.
WARNING: Do not plug in or turn on the tool until it is fully assembled according to the instructions. Failure
to follow the safety instructions may result in serious personal injury.
A
E
F
B
G
DC
To Next Page
Loading...
Need help?
General
