WEST 8800 - Page 4

4 8800 process controller
4.5 Configuration examples ......................53
4.5.1 On-Off controller / Signaller (inverse) .................53
4.5.2 2-point controller (inverse) .......................54
4.5.3 3-point controller (relay & relay) ....................55
4.5.4 3-point stepping controller (relay & relay) ...............56
4.5.5 Continuous controller (inverse) .....................57
4.5.6 ∆ - Y - Off controller / 2-point controller with pre-contact ......58
4.5.7 8800 process controller with measured value output ..........59
4.5.8 Continuous controller with integrated positioner ( Cntr/ C.Fnc = 6 )60
5 Parameter setting level ......................61
5.1 Parameter survey ........................61
5.2 Parameters .............................62
5.3 Input scaling ............................65
5.3.1 Input Inp.1 and InP.3 .............65
5.3.2 Input InP.2...............................66
6 Calibration level .........................67
7 Special functions .........................70
7.1 DAC
®
– motor actuator monitoring ...............70
7.2 O
2
measurement ..........................72
7.2.1 Connection ...............................72
7.2.2 Configuration: ..............................73
7.3 Linearization ............................74
7.4 8800 process controller as Modbus master ............75
8 8800/8840 configurator ......................76
9 Versions ..............................77
10 Technical data ..........................78
11 Safety hints ............................81
11.1 Resetting to factory setting.....................82
12 Notes ................................83