Westerbeke 7.0 BCG - Remote Oil Filter

REMOTE OIL FILTER'(OPTION_AL)
PN. 040078
INSTALLATION
This popular accessory is used to relocate the engine's oil til-
ter from the engine to a more convenient location such as an
engine room bulkhead.
NOTE: Refer to ENGINE OIL CHANGE in this nu.mual for
instructions on removing the oll filter.
To install, simply remove the engine oil filter and thread on
WBSTERBEKB's remote oil filter kit as shown. Always
install this kit with the oil filter facing down as illustrated.
Cont.act your WESTERBBKE dealer for more information.
APPLY A lHIN COAT OF CLEAN OIL TO lllE IHllNG WHEN
INSTALLING THIS KIT. THRWI THE KIT ON, 1llEH ~
TIGHTEN AN ADDmONAL 3/4 TURN AFTER THE 0-RING
CONTACTS THE~
THEGUrCONNECTIONHOSE
MUST ATTACH TO THE IN
CONNECTION AT THE
REMOTE OIL FILTER.
Nm: Westerbeke is notresponsible for engine fail1.1re due to
incorrect installation of the Remote Oil Filter.
A CAUTION: It is vital to Install tbs on 111111$ cor-
rsattr. If thB oil flows In t/IB ,,_,.. dilllDtlon, tile by·
pass valvll In tile mter: ll$Sllllbty will pnw1111t tbs all
frtllll·~ tile ••n• t:a~t1111 a1Jtnt11111a1111g1n1
falln. If ttlel'S Is no oitpnis$1frs ,.,.,,,,,,, $hufd0wn.
- lmmedialllly aad.t:het:k tllfl bOStJ OOIHlflDtlOllS.
APPLY A THIN CO~ OF CLEAN OIL TD lRE FILTER
GASKET WHEN INSTALLING. l\FTER lRE ALTER
CQ.NTACTS THE BASE. TIGHTEN IT AN ADDITIONAL·
Engines & Generators
21