Westerbeke 7.0 BCG - Shore Power Transfer Switch

SHORE POWER TRANSFER SWITCH
120 VOLT/60 HER'll TWO WIRE CONFIGURATION
Switching Shore Power to Generator Power
If the installer connects shore power to the vessel's AC
circuit, this must be done by means of the Shore Power
'Il.'ansfer Switch .. Set the transfer switch shown in the
diagrams. to the OFF position. This switch prevents
simultaneous connection· of shore power to generator output.
A CAUTION: Damage ta the ge11Brator can resun ff
utility shore power and generator output are connected
at the same time. This type of generator damage Is not
coVBl'fJd under the warranty; It Is the Installer's rssponsl·
bllity ta make sure all AC connections are col'TBl:t.
. NOTE: Diafll'UI - -ctl- fer a two-
Wire, 12Q•Volt .,.. ... ffOm - ..,._,
- ... ,..-1 ... 120-VOlt -t .,... ....
. A CAUTION: Heavy motor leads.should bs shut og
before switching shore power to generator power or
rlt:B-versa because voltage surges Induced by switching
with hBaVy AC loads an the vessel being operated may
caUStJ damage to the exciter cltcull compollflnts In the
gllllflrator.
"6-nltor NOTE: Dialdlll llllowll con•ct- for a --
1 N 13
1
•
G2 1 wire.120-Volt uatem. Far • three• wire syatern
t .=. - dotted 11- for the -· bot 199·
I
:
I
I
I
..... -,
L---~ ft
r--:---\<a> /
I , __ .,.
I
I
I
I
Eng~ne_s &_Generators
- 39