Western Leonardo User Manual

Leonardo Datalogger
Manuale utente
User manual
IT
EN

Western Leonardo Specifications

General

Resolution	16-bit
Input Voltage Range	±10 V
Connectivity	USB
Measurement Parameters	Voltage, Current, Temperature
Measurement Range	±10 V (voltage), Varies (current and temperature)
Communication Interface	USB
Channels	8

Summary

Datalogger Installation Procedure

External Charge Controller Connection

Setting WRM30 Addresses

Guide on setting node ID addresses for charge controllers via the SETUP menu.

Serial Inverter Connection

Internet Connection of the Datalogger

Leonardo Datalogger Power Supply

Datalogger Status Reports

LED Status Signalling

Table detailing the meaning of the Green and Yellow status LEDs on the datalogger.

System Registration with Leonardo Monitor App

Display on Leonardo Monitor App

Displaying Data on the Web Portal

Firmware and Software Management

Firmware Update Process

Steps for upgrading the datalogger's firmware using the Leonardo Config software.

Static IP Address Setting

Procedure to configure a static IP address for the datalogger via the software.

Format SD Card

Instructions on how to format the SD card within the Leonardo Datalogger using the software.

Inverter Compatibility Update

Mechanical Characteristics

Electrical Characteristics

Warranty Information

Waste Disposal Guidelines