www.whiskersuppo.com
16
Clean Cycle
Aer your cat leaves the Globe, the Lier-Robot automatically peorms a Clean cycle. The
siing system separates the clumps from the clean lier and deposits them into the Waste
Drawer below. It will take 2 minutes to complete the Clean Cycle. You can also press the
Cycle buon to sta a Clean cycle.
During a Clean cycle, press any buon to pause the cycle. Press the Cycle buon to resume
the cycle. Press the Reset or Empty buon to abo the cycle and return the Globe to the
Home position.
How it works:
The Lier-Robot is ready for use when the Globe is at the Home position and the Light Bar on
the Control Panel is blue.
1. When a cat enters the Globe, the Cat Sensor(s) are activated; the blue Light Bar
changes to red.
2. Once the cat exits the Globe, a countdown to the Clean cycle begins. When the (see
page 24) has elapsed, the red Light Bar changes to a yellow round robin Light Bar
indicating the counterclockwise Globe rotation of the Clean cycle.
3. As the counterclockwise rotation continues, clean lier passes through the
low-dust screen while lier clumps are separated from the clean lier. The clean
lier is collected behind the septum.
4. During rotation, and while the Globe is upside down, an integrated weight within the
boom of the Flexible Globe Liner causes the liner to fall away from the Globe to
ensure any stuck-on clumps are removed.
5. As the Globe rotates toward the Dump position, the waste clumps fall through the
Waste Po into the Waste Drawer below.
6. The Globe then stops at the Dump position and begins to rotate clockwise, back to-
ward the Home position. The Flexible Globe Liner falls back into place and clean lier
spills back into the boom of the Globe.
7. The Globe will rotate past the Home position to level the lier before nally
re turning to the Home position. The sequential round robin yellow Light Bar
changes to the blue Light Bar, indicating the unit is ready for the next use.
To Next Page
Loading...
Need help?
General
